Use and Care Manual

14
Model 50514
Problem Possible cause Solution
Handle not in position Carriage bolts not seated properly.
Handle knobs not tightened.
Adjust the height of the handle and make
sure the carriage bolts are seated properly.
Tighten handle knobs.
Mower not starting. Power supply not connected. Connect to power supply.
Mower cutting grass
unevenly.
Lawn is rough or uneven.
Cutting height is not set properly.
Check mowing area.
Move the wheels to a higher setting.
Mower hard to push. High grass, rear of mower housing and
blade dragging in heavy grass, or cutting
height too low.
The rear of the grass catcher is dragging
in thick grass.
Raise cutting height.
Empty grass clippings from the grass catcher.
Mower vibrating at higher
speed.
Blade is unbalanced.
Bent motor shaft.
Balance the blade by grinding each cutting
edge equally.
Stop the motor, remove battery, and inspect
for damage. Have repaired by an authorized
service center before restarting.
Motor stops while cutting. Cutting height set too low. Raise the cutting height.
TROUBLESHOOTING
CALL US FIRST !!
Call us first with questions about operating or maintaining this product at 1.800.313.5111
between 8:00 a.m. – 5:00 p.m. Eastern Standard Time, or get assistance on
www.americanlawnmower.com.