Instruction Manual

Table Of Contents

PARTS REQUIRED:

FIGURE 2

8 pcs - H1 Phillips Round Head Screw 2 pcs - P2 End Apron

8 pcs - H6 Allen Head Bolt 2 pcs - A2 6mm Allen Wrench

8 pcs - H7 Flat Washer 1 pc - A3 4mm Allen Wrench

STEP 2:

Attach P2 End Aprons to previous assembly STEP 1 using H6 Allen Head Bolts with H7 Flat Washers as shown in

FIGURE 2. Do not tighten H6 Allen Head Bolts on this time.

Please make sure P3 Playfield is flush with both ends of P2 End Apron, tighten H6 Allen Head Bolts using A3 Allen

Wrench on this time.

Secure P3 Playfield to P2 End Apron using pre-drilled holes with H1 Screws as shown in FIGURE 2.

IMPORTANT NOTE: All screws must be screwed STRAIGHT down. Tighten, but do not strip out H1 Screws.

Using A2 Allen Wrenches to tighten H4 Support Rod Nuts as shown in FIGURE 2.

IMPORTANT NOTE:

Bottom of P1 Side Aprons and P2 End Aprons

must be flush with each other before tightening

H6 Allen Head Bolts.

IMPORTANT NOTE:

P3 Playfield must be flush with each

end of P2 End Aprons before

tightening H6 Allen Head Bolts.

2014 Escalade Sports

For Customer Service Call 1-888-996-2729