Manual

©2014 American Lighting
Denver, CO 80231 Made in China
www.americanlighting.com
LED CANOPY LIGHT
Installation instructions for GC-20 Series
RV-1435
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE FIXTURE. FAILURE TO FOLLOW
INSTALLATION INSTRUCTIONS AND ALL APPLICABLE ELECTRICAL CODES WILL VOID THE PRODUCT WARRANTY.
WARNING:
These products may represent a possible shock or fire hazard if improperly installed or attached in any
way. Products should be installed in accordance with these instructions, current electrical codes and/or
the current National Electric Code (NEC).
WARNING:
Disconnect supply power from the source prior to installation. This product must be installed by a person
familiar with the construction and operation of the product and the hazards involved, and in accordance
with current electrical codes and/or the current National Electric Code (NEC). Consult a local licensed
electrician if you are not sure about the installation. To reduce potential of electric shock, fixture must be
grounded. The electrical input of this product is 120-277V AC. The installer must determine whether
power supply in in the range of 120-277V AC at the luminaire before installation.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage the wire
insulations. Do not restrict fixture ventilation. Do not cover fixtures with insulation or any material that
will impede air flow around and heat dissipation of the fixtures.
APPLICATION / USE:
This product is suitable for use in wet locations and designed for surface mounting only. This xture is
suitable for installation where ambient temperatures do not exceed 104˚F (40˚C) during anticipated
hours of fixture operation.
ADDITIONAL SAFETY MEASURES:
1. LEDs are not serviceable. Do not attempt to open the fixture or LED compartment.
2. LEDs are bright. Do not look directly into fixture.
3. Not intended for recess mounting in any type of installation.
4. Do not use with wall dimmers or in dimming circuits.
Note: These instructions do not cover all details or variations in equipment nor do they
provide for every possible situation during installation, operation or maintenance.
INSTALLATION:
Disconnect supply power from the source prior to installation.
Installation requires T20 Security Torx Bit
1. Remove old fixture if applicable.
2. Remove the J-box mounting plate from the top of the fixture
by loosening one side screw and sliding the fixture plate out
from the holding brackets on the top of the housing.
See Figure 1.
3. Install mounting plate to J-box with two screws (not included).
Note: Bracket should be positioned squarely with respect to
the fixture. See Figure 2.
4. Hang fixture from support spring while wiring the unit. Connect
fixture’s lead wires to AC supply wires using appropriate UL
Listed electrical connectors as follows: connect line voltage
(hot) AC supply wire (Black) to the line voltage AC wire (Black);
connect neutral (common) AC supply wire (White) to the
neutral AC wire (White); and connect the ground AC supply
wire (Green or bare wire) to the ground AC wire (Green wire).
5. Connect main housing to the junction box bracket by pushing
the housing up onto the 4 top brackets. Hold in place while
reinstalling the side screw.
6. Turn on power. Fixture will reach full output in several seconds.
Figure 1
Mounting
plate
Fixture
Figure 2
Mounting
plate
Side screw
J-box
Side screw