Manual

These products may represent a possible shock or fire hazard if improperly installed or attached in
any way. Products should be installed in accordance with these instructions, current electrical codes and/or
the current National Electric Code (NEC).
4” LED Recessed Downlight
Installation instructions for E4 Series and LD4 Series
WARNING:
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. Make sure that the electrical power to the fixture is disconnected prior to any installation or retrofit.
3. Use with 4” recessed cans (recessed housings) only. Do not attempt to alter for other sizes or purposes.
2. This light is suitable for damp locations.
Figure 1
Steel spring clips
WARNING: Risk of re or electric shock. Install these kits only in 4” recessed housings. Conrm this before
installation by checking the interior of the housing for a manufacturer’s part number and specications; or
measure the diameter of the housing. The recessed housing must have a minimum measured inside
diameter (opening) of 4”; maximum diameter 4-5/8”; minimum clearance of 2-3/4” for E4 Series and
minimum clearance of 3-7/8“ for LD4 Series. See Figure 1.
Do not make or alter any open holes in a wiring enclosure, nor in any electrical components during kit
installation! WARNING: Risk of re or electric shock. Kit installation requires knowledge of recessed lighting
luminaires electrical systems. If not qualied, do not attempt installation. Contact a qualied electrician.
Do not use these products in luminaires located where elevated ambient temperatures exist.
WARNING: Risk of re or electric shock. The electrical rating of this product is 120V AC. The installer must
determine whether power supply is 120V AC at the luminaire before installation.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other
sharp objects.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A FLUORESCENT LUMINAIRE WHERE THE SUIT-
ABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR AUTHORITIES HAVING JURISDICTION.
Each xture includes an attached lead wire with a 120V plastic connector for use with either a GU24
adaptor, sold separately or with an E26 adaptor, which is included, an insulating foam ring and a set of
attached steel spring clips. See Figure 1.
FUTURE LAMP REPLACEMENT
E4 Series models and LD4 Series models are available from American Lighting.
Contact 800.880.1180 or visit www.americanlighting.com to find a local distributor.
2-3/4” for E4 Series
120V plastic connector
E26 adaptor
GU24 adaptor
3-7/8” for LD4 Series
120V plastic connector
E4 Series (with GU24 or E26 socket adaptor) LD4 Series (with GU24 or E26 socket adaptor)
E26 adaptor
GU24 adaptor
Insulating
foam ring
Steel spring
clips
Insulating
foam ring
E4 Series (E26 socket adaptor
with lead wire)
LD4 Series (E26 socket
adaptor with lead wire)
pg 1 of 2
Denver, CO 80231 www.americanlighting.com
© 2012 American Lighting, Inc RV1216

Summary of content (2 pages)