Manual

Installation instructions for E4 Series and LD4 Series

CAUTION: Always make sure power to the fixture is disconnected before beginning removal of

existing lamp and/or trim, or before beginning retrofit installation. Failure to do so can cause

electric shock, which can result in injury or death.

RETROFIT INSTALLATION

1. Confirm the LED trim is compatible with the recessed housing as outlined on reverse.

2. Remove existing lamp from existing recessed housing.

3. Remove existing trim from existing recessed housing.

4. Detach GU24 or E26 socket adaptor from LED fixture by grasping plastic connectors

firmly and pulling apart. Do not grasp wires to pull connectors apart. See Figure 2.

5. Screw E26 socket adaptor into existing E26 socket at the back of the housing; or push

and twist GU24 socket adaptor into existing GU24 socket at back of housing. See Figure 3.

6. Insert male connector pins into female connector and press firmly together until fully

seated. See Figure 4.

7. Anchor fixture to recessed can, aligning steel spring clips with interior wall of can, and

push fixture gently to ceiling until seated. See Figure 5.

Figure 2

Figure 4

Recessed

housing

Ceiling

Figure 3

Insert male connector

pins into female

connector and press

firmly together until

fully seated

Steel spring

clips

pg 2 of 2

Denver, CO 80231 www.americanlighting.com

NEW CONSTRUCTION INSTALLATION

Follow steps 1, then 4-7 above.

4” LED Recessed Downlight

Figure 5

E4 Type Installed

LD4 Type Installed

Ceiling

Recessed

housing