Installation Guide

MOUNTING MICROLINK (Figures 1 & 2):
Magnet Installation (See Figure 1)
1. The Microlink fixtures come with a set of magnets pre-installed on
the underside of the fixture. To secure to a ferrous surface, simply
space the magnets to bear the weight of the fixture and place on
surface.
Mounting Clip Installation (See Figure 2)
1. If using mounting clips (either ½ in or 4 in), be sure to position and
mark their location in a straight line so that the fixture can snap
into each.
2. Using screws, install mounting clips in line, taking into account the
lengths of each fixture being used.
3. Clip/snap the groove sides of the Mlink into mounting clips
Note: Begin with first fixture of run attached to surface and add
additional fixtures to the run one at a time.
LINKING MICROLINK (Figure 3):
1. To link fixtures, align the peg-and-slot connector and apply light
force from above. Fixtures will snap together.
2. Terminate runs with the provided end cap.
POWERING MICROLINK (Figure 4):
This LED product is designed to be used with a regulated 24V DC
power supply only. Be sure to select a driver with a wattage capacity
that can handle the total load, noting the following wattage for each
size: MLINK-30-6 = 2.1 watts, MLINK-30-16 =5.7 watts, MLINK-30-22 =
7.9 watts and MLINK-30-32 =12.2 at the source prior to installation or
maintenance.
1. Ensure all parts and pieces have been correctly linked and
mounted. The first fixture in a run should have a power connection
with female DC lead attached and the last fixture in a run should
have an end cap attached.
2. For hardwire drivers (such as the ADPT-DRJ series), use a 2-wire
DC adapter (DC-HW) to ax a male DC connection to the driver.
Connect power cord from Microlink to 24V DC power supply by
connecting DC connectors. Provide line voltage power to the
driver by wiring according to driver instructions
3. For plug-in drivers (such as the PS-Series), connect power cord
to 24V DC power supply by connecting DC connectors. Provide
line voltage power to the driver by plugging in to a standard wall
socket.
Note: Recommended power supplies include PS-Series Plug-in Drivers
and ADPT-DRJ power supplies. See “Power Supplies and Drivers” at
www.americanlighting.com for details.
CARE AND MAINTENANCE:
1. For cleaning, use a soft, dry or damp cloth. Do not use harsh chemicals or abrasives.
CARE AND MAINTENANCE:
To dim Microlink fixtures, most standard 2-wire and CL dimmers may be used. Results vary depending on load and wall dimmer choices
(approximately 5-100% light control).
Page 2 of 2©2019 American Lighting, Inc. REV1931 www.AmericanLighting.com 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: [phone]
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
MICROLINK Linkable LED Light Fixture24V
INSTALLATION INSTRUCTIONS
MLINK-30-XX
Magnets
Ferrous Metal Surface