User`s guide

MegaRAC G3 User’s Guide
126
MegaRAC G3 Card Remote Recovery Application (RRA), Continued
Step Description
1 Left click the Card Settings button to begin.
The Active Cards in Recovery Mode screen appears and starts to search for MegaRAC G3 cards in
Recovery Mode.
Left click the MegaRAC G3 card’s MAC address that you want to configure.
The Active Cards in Recovery Mode buttons are explained in the table below:
Button Description
Stop The Stop button allows you to stop searching the network for active cards in Recovery
Mode.
Refresh The Refresh button allows you to start searching the network again for MegaRAC G3
cards’ MAC addresses in Recovery Mode.
Select The Select button allows you to specify the highlighted MegaRAC G3 card’s settings.
You can specify the MegaRAC G3 card’s MAC, IP, Network Mask, and Gateway
addresses as shown in the following step.
2
Cancel The Cancel button allows you to cancel any new settings that are not saved.
Cont’d