User`s guide

MegaRAC G3 User’s Guide
138
Before You Start, Continued
Avoid Electro-Static Discharge (ESD), Continued
Perform all unpacking and installation procedures on a ground-connected anti-static mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat. You can
also use a sheet of conductive aluminum foil grounded through a one megaohm resistor
instead of the anti-static mat. Similarly, a strip of conductive aluminum foil wrapped
around the wrist and grounded through a one megaohm resistor serves the same purpose
as a wristband.
Modem Daughterboard Installation
The MegaRAC G3 modem daughterboard is an optional component. Use the following
steps to install the modem daughterboard onto the MegaRAC G3 card.
Step Action
1 Unpack the modem daughterboard.
2 Locate JP10 on the MegaRAC G3 card. It has a series of pinholes that allow you to insert the modem
daughterboard. Match the modem daughterboard and the pin holes so that the pins align properly. Insert
the modem daughterboard by sliding it straight down into the MegaRAC G3 card. See the illustrations on
the following page.
Note: If the MegaRAC G3 card is already installed into a host system, power down the host system
and MegaRAC G3 card first. Physically unplug all external and internal cables from the
MegaRAC G3 card. Remove the MegaRAC G3 card from the host system.
3 Plug in the MegaRAC G3 card into the host system and attach internal cables
4 Connect external cables
Note: For the complete
MegaRAC G3 card installation procedures, see your MegaRAC G3 Remote
Management Card User’s Guide located on the MegaRAC™ G3 CD.
Note: Inspect the cardboard carton for obvious damage.
Cont’d