User`s guide

MegaRAC G3 User’s Guide

Step 3 Install the Optional Modem Daughterboard

The MegaRAC G3 modem daughterboard is an optional component. Locate JP10 on the

MegaRAC G3 card. It has a series of pinholes that allow you to insert the modem

daughterboard. Match the modem daughterboard and the pin holes so that the pins align

properly. Insert the modem daughterboard by sliding it straight down into the MegaRAC

G3 card. See Appendix F : Modem Daughterboard for more information.

Note: The optional modem is NOT designed for Console Redirection. However, you can still

perform Console Redirection, but it is debilitating and extremely slow.

Note: As of March 15

, 2004, the MegaRAC G3 firmware does not support the optional

modem.

Step 4 Plug in the MegaRAC G3 Card into the Host System and Attach

Internal Cables

Physically plug in the MegaRAC G3 card into any available PCI slot inside the host

system.

J3 Service Connector

This jumper is used exclusively for servicing the MegaRAC G3 card. J3 is not described

in this document.

J4 JTAG (Joint Test Action Group) ICE (In-Circuit Emulator) Connector

This header is used to debug and service the MegaRAC G3 card. J4 is not described in

this document.

Cont’d