Installation Guide
• Tile may be installed over most structurally sound
substrates.
• Make sure surface is clean, smooth, dry and free
of wax, soap scum and grease.
• Any damaged, loose or uneven areas must be
repaired, patched and leveled.
• Remove any moldings, trim, appliances or
anything that could interfere with installation.
1
WALL TILE INSTALLATION INSTRUCTIONS PAGE 1 of 4
• Find the center point of the wall, using a level to draw
a plumb line in the wall’s center.
• Lay out a row of loose tiles across the bottom of
the wall from the center line leaving uniform joints
between tiles.
NOTE: Tiles can be butted together leaving a
consistent 1/16 in. joint automatically.
TIP: If cuts leave tiles smaller than half to their
original size, adjust the center line a half tile closer to
the wall.
• Stack two tiles here. At the top, draw a horizontal line
on the wall and continue the line around all side walls
to be tiled.
Continued on next page
STEP 1:
SURFACE PREPARATION
Continued on next page
2
STEP 2:
LAYOUT
INSTALLATION
WALL TILE