Installation Instructions

P a g e | 3
Installing the last panel on each wall with nails Ref29-2
1 – Measure and record the distance between the installed panel and the corner, at several places[2]
2 – Beginning at the edge of the last panel, measure and mark distances you just recorded
3 – Using measured marks as a guide, draw a reference line on the ‘last’ panel
4 – Cut the panel and ‘dry-fit’ the panel in position
5 – If panel doesn’t fit, trim it until it fits, then sand the cut edge lightly
6 – Drive two nails into the top edge[3] and position the last panel in place
7 – Push the last panel against the previous panel, then drive the two nails into the wall
Spacing of additional nails on partially installed panels. Ref30