Master Switch User Guide AP9210

MasterSwitch 100V – User Guide

Chapter 5:

Controlling the

MasterSwitch

This chapter describes how you can use Web, SNMP or console commands (telnet or serial sessions) to control

output power from the MasterSwitch, as a unit, or from each outlet, individually.

Overview

Using configuration options (Chapter 4) you can control power output from the MasterSwitch by defining

such values as when master power is supplied to the outlets, and then sequence the power output from each

outlet. The MasterSwitch control options allow you to further control the power output, as follows:

n You can use a master power control to turn all outlets on, turn all outlets off or reboot all outlets.

n You can use outlet controls to turn on, off or reboot an individual outlet.

Master Power Control

You can use Web, SNMP or console commands to control master power to the MasterSwitch outlets:

n You can turn all outlets off immediately.

n You can turn all outlets on immediately.

n You can turn all outlets on in sequence (as defined by an outlet’s power on delay value).

n You can reboot all outlets immediately.

n You can reboot all outlets in sequence (as defined by an outlet’s power on delay value).

Outlet Power Control

You can use Web, SNMP or console commands to control the power output from each MasterSwitch outlet:

n You can turn an outlet off.

n You can turn an outlet on.

n You can reboot the equipment (turn power off and then back on), with the duration of the reboot cycle

defined by the reboot duration value you configured for the MasterSwitch outlets.