Master Switch User Guide AP9210

9
MasterSwitch 100V – User Guide
9
Front Panel
The primary feature of the MasterSwitch is the programmable control of eight power outlets using embedded
Web-based control,
SNMP control, or the console program via telnet or the onboard serial port. Two
connectors provide for the physical link for programming:
n A built-in serial port, which connects a terminal (or terminal emulator) to access the console program.
n A built-in 10Base-T network connector, which connects the MasterSwitch to an Ethernet LAN to
allow using the embedded Web control, telnet, or
SNMP to configure the MasterSwitch. The
MasterSwitch must connect to an Ethernet
LAN to use telnet, SNMP or embedded Web control.
As shown in Figure 1, both of these connectors are located on the front panel. Figure 1 also identifies the
following:
n Eight receptacle LEDs. When an outlet is on, the corresponding LED is lit.
n Two network status LEDs—Status and Link - TX/RX. LEDs provide visual indications about the
Ethernet LAN connection.
n A reset button, which reinitializes the MasterSwitch without affecting its outlet power.
Figure 1: MasterSwitch Front Panel