Quick Start Guide

3/4
4 Align the holes at the end of each rail-slide
assembly with the caged nuts installed in Step 2.
Loosely fasten to the enclosure using the screws and
cup washers provided.
Note: The length of the Sliding Shelf rails should
adjust to match rack depth. Loosen the 3/8"
nuts, if necessary, to adjust the length.
5 Install the shelf assembly (refer to steps A and B
shown at right):
A. Fit the rear of the shelf slide into the front end
of the slide on the mounted rail-slide assembly
and slide forward until it stops with a click
(about 8").
B. Push the release lever on each side of the rail
assembly and push the shelf the rest of the way
forward.
6 Tighten the 8 screws on the vertical mounting rails.
7 Tighten the nuts on the adjustable rail.
8 Place the 4 friction pads on the shelf according to
the footprint of the equipment you are installing on
the shelf. Place the edges of the friction pads
parallel to the edges of the shelf.
9 Carefully lower the equipment onto the
friction pads.
Step Action Figure