Installation Guide

Page | 1

POLYURETHANE CORBELS INSTALLATION

TOOLS:

 Pencil

 Safety goggles

 Hammer or finishing nailer

 Caulking gun

 Paint brush

 Putty knife

MATERIALS:

 6d or 8d finishing nails (bright

finish or lector-galvanized)

 Polyurethane Corbels

 Premium Polyurethane

construction adhesive

 Painters Caulk

 Clean cloth or sponge

 High quality Acrylic latex or Oil

based paint

 220 grit sandpaper

SAFETY

Wear safety goggles when installing and finishing Polyurethane Corbels.

WALL AND CEILING PREPARATION

Prior to installing Corbels make sure walls and ceilings are

 dust free

 dry

 grease free

If needed, lightly sand and wipe surface with a damp cloth.

PAINTING

Corbels can be painted either before installation or after. It is up to the installer.

Use a high quality Acrylic Latex or Oil based paint. Corbels are factory pre-primed

and ready to paint or faux finish.

PAGE 1
POLYURETHANE CORBELS INSTALLATION TOOLS:   Pencil Safety goggles Hammer or finishing nailer Caulking gun Paint brush Putty knife     MATERIALS:  6d or 8d finishing nails (bright finish or lector-galvanized)  Polyurethane Corbels  Premium Polyurethane construction adhesive  Painters Caulk  Clean cloth or sponge  High quality Acrylic latex or Oil based paint  220 grit sandpaper SAFETY Wear safety goggles when installing and finishing Polyurethane Corbels.
PAGE 2
INSTALLATION Polyurethane Corbels can be glued, nailed or both.  Apply a continuous ¼” bead of premium polyurethane construction adhesive along the back edges of the corbel. Wipe away any excess glue immediately before it can harden. Then once glue is dried, repeat if necessary with adhesive or filler.  Hold down Corbel into place. Make sure it is tight against both the ceiling and the wall. By having both edges tight against the ceiling and the wall will provide consistency and a correct angle.