Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareBlack Solid Steel Sliding Rolling Barn Door Hardware Kit for Double Wood Doors With Routed Floor Guide

• Plumb Line

• Wrench

• Pencil

• Phillips Head Screwdriver

• 8mm Drill Bit

• 5.5mm Drill Bit

• 10mm Routing Drill Bit

• Level

• Tape Measure

• Power Drill

F G H

J K

Door Roller Hardware x4

M8x60 Bolt x9

M8x30 Wall Anchor x9

Wall Bracket x9

ST8x90 Bolt + Washer x9

Routed Floor Guide x2

Floor Anchor x4

ST4.2x25 Screw x4

Door Stop x4

4mm/8mm Allen Keys x1

Anti-Jump Disk x4

68-7/8" Rail x2

MODEL No.

5APD10651

INSTALLATION MANUAL

HARDWARE KIT

FOR SLIDING DOUBLE WOOD DOORS

TOOLS REQUIRED INCLUDED IN KIT

American Pro Decor assumes no liability for improper installation.

Summary of content (5 pages)

PAGE 1
HARDWARE KIT FOR SLIDING DOUBLE WOOD DOORS MODEL No. INSTALLATION MANUAL 5APD10651 A B FGH E I C D J K L TOOLS REQUIRED INCLUDED IN KIT A B C D • Plumb Line • Wrench • Pencil • Phillips Head Screwdriver • 8mm Drill Bit • 5.5mm Drill Bit • 10mm Routing Drill Bit • Level • Tape Measure • Power Drill E F G H I J K L Door Roller Hardware x4 M8x60 Bolt x9 M8x30 Wall Anchor x9 Wall Bracket x9 ST8x90 Bolt + Washer x9 Routed Floor Guide x2 Floor Anchor x4 ST4.
PAGE 2
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown. NOTES Wall Blocking To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. Consult a structural engineer if you have questions about what type of wall blocking is required. Join the two rails together.
PAGE 3
Drill out holes in the doors using a 10mm routing drill bit as pictured. The bottom of the doors should be routed at this time in order to accept the floor guide. Attach the anti-jump disks to the tops of the doors. Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident. American Pro Decor assumes no liability for improper installation.
PAGE 4
Plumb the doors and mark the positions of the floor guides. Mount the floor guides to the floor. Adjust the door stops accordingly. American Pro Decor assumes no liability for improper installation.
PAGE 5
Install the end cap covers. American Pro Decor assumes no liability for improper installation.