Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareStainless Steel Sliding Rolling Barn Door Hardware Kit for Double Wood Doors With Routed Floor Guide

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 10mm Drill Bit

• 5.5mm Drill Bit

• Level

• Tape Measure

• Power Drill

C D

H I J K

67-7/8" Rail x2

Door Roller Hardware x4

Adjustable Installation Wrench x1

4mm/8mm Allen Keys x1

Splicer x1

Center Bracket x5

End Bracket x2

ST5.5x32 Screw x6

Floor Anchor x6

Routed Floor Guide x2

Door Stop x4

ST4.8x50 Bolt x7

MODEL No.

5APD10656

American Pro Decor assumes no liability for improper installation.

INSTALLATION MANUAL

TOOLS REQUIRED INCLUDED IN KIT

HARDWARE KIT

FOR SLIDING DOUBLE WOOD DOORS

304 Grade Stainless Steel

Summary of content (4 pages)

PAGE 1
HARDWARE KIT FOR SLIDING DOUBLE WOOD DOORS 304 Grade Stainless Steel MODEL No. INSTALLATION MANUAL 5APD10656 A F B L G C TOOLS REQUIRED D E H I J K INCLUDED IN KIT A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 10mm Drill Bit • 5.5mm Drill Bit • Level • Tape Measure • Power Drill E F G H I J K L 67-7/8" Rail x2 Door Roller Hardware x4 Adjustable Installation Wrench x1 4mm/8mm Allen Keys x1 Splicer x1 Center Bracket x5 End Bracket x2 ST5.
PAGE 2
NOTES Wall Blocking 1. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. 2. Adjustable mounting brackets allow for standard 16" U.S. stud spacing, or any variation. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
PAGE 3
1. Remove the anti-rise pin and drill holes centered in door thickness. The doors should be routed at this time. 2. Mount the rolling straps to the door. Position the doors on the rail. Adjust the stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 4
Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment. Reattach the anti-rise pin to the door rollers American Pro Decor assumes no liability for improper installation.