Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareStainless Steel-304 Grade-Sliding Rolling Door Hardware Kit for Single Glass Doors With Fittings

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 8mm Drill Bit

• 5.5mm Drill Bit

• Level

• Tape Measure

• Power Drill

B C D

F G H I

78-3/4" Rail x1

Door Roller Hardware x2

End Bracket x2

Center Bracket x2

ST4.8x50 Bolt x4

Floor Guide x1

Floor Anchor x2

ST4.8x32 Screw x2

Door Stops x2

Adjustable Installation Wrench x1

4mm/8mm Allen Keys x1

MODEL No.

5APD10658

American Pro Decor assumes no liability for improper installation.

INSTALLATION MANUAL

TOOLS REQUIRED INCLUDED IN KIT

HARDWARE KIT

FOR SLIDING SINGLE GLASS DOORS

304 Grade Stainless Steel

Summary of content (4 pages)

PAGE 1
HARDWARE KIT FOR SLIDING SINGLE GLASS DOORS 304 Grade Stainless Steel MODEL No. INSTALLATION MANUAL 5APD10658 A B C D F J TOOLS REQUIRED G H E I K INCLUDED IN KIT A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 8mm Drill Bit • 5.5mm Drill Bit • Level • Tape Measure • Power Drill E F G H I J K 78-3/4" Rail x1 Door Roller Hardware x2 End Bracket x2 Center Bracket x2 ST4.8x50 Bolt x4 Floor Guide x1 Floor Anchor x2 ST4.
PAGE 2
NOTES Wall Blocking 1. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. 2. Adjustable mounting brackets allow for standard 16" U.S. stud spacing, or any variation. Suggested wall bracket spacing. Brackets must be secured into wall blocking. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking.
PAGE 3
Remove the anti-rise pin and drill holes centered in door thickness. Mount the rolling straps to the door. Position the doors on the rail. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 4
Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment. Reattach the anti-rise pin to the door rollers American Pro Decor assumes no liability for improper installation.