Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareStainless Steel-304 Grade-Sliding Rolling Door Hardware Kit for Double Glass Doors With Fittings

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 8mm Drill Bit

• 5.5mm Drill Bit

• Level

• Tape Measure

• Power Drill

D E

F G H

J K L

67-7/8" Rail x2

Door Roller Hardware x4

Center Bracket x4

End Bracket x4

ST4.8x50 Bolt x8

Floor Guide x2

Floor Anchor x4

ST4.8x32 Screw x4

Adjustable Installation Wrench x1

4mm/8mm Allen Keys x1

Splicer x1

Door Stops x4

MODEL No.

5APD10659

American Pro Decor assumes no liability for improper installation.

INSTALLATION MANUAL

TOOLS REQUIRED INCLUDED IN KIT

HARDWARE KIT

FOR SLIDING DOUBLE GLASS DOORS

304 Grade Stainless Steel

Summary of content (4 pages)

PAGE 1
HARDWARE KIT FOR SLIDING DOUBLE GLASS DOORS 304 Grade Stainless Steel MODEL No. INSTALLATION MANUAL 5APD10659 A C B D I TOOLS REQUIRED E F J G H K L INCLUDED IN KIT A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 8mm Drill Bit • 5.5mm Drill Bit • Level • Tape Measure • Power Drill E F G H I J K L 67-7/8" Rail x2 Door Roller Hardware x4 Center Bracket x4 End Bracket x4 ST4.8x50 Bolt x8 Floor Guide x2 Floor Anchor x4 ST4.
PAGE 2
NOTES Wall Blocking 1. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. 2. Adjustable mounting brackets allow for standard 16" U.S. stud spacing, or any variation. Suggested wall bracket spacing. Brackets must be secured into wall blocking. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking.
PAGE 3
Remove the anti-rise pin and drill holes centered in door thickness. Mount the rolling straps to the door. Position the doors on the rail. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 4
Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment. Reattach the anti-rise pin to the door rollers American Pro Decor assumes no liability for improper installation.