Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareBlack Solid Steel Sliding Rolling Barn Door Hardware 8 ft. Kit for Single Wood Doors

TOOLS REQUIRED

INCLUDED IN KIT

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 8mm Drill Bit

• 10mm Routing Drill Bit

• Wrench

• Level

• Tape Measure

• Power Drill

G H I

J K L

Door Roller Hardware x2

96" Rail x1

Wall Bracket x6

2.5mm Allen Key x1

Door Stop x2

Anti-Jump Disk x2

Routed Floor Guide x1

Floor Anchor x2

ST4.2x25 Screw x2

M8x30 Wall Anchor x6

M8x60 Bolt + Washer x6

M8x90 Bolt x6

MODEL No.

5APD10753

INSTALLATION MANUAL

HARDWARE KIT

FOR SLIDING SINGLE WOOD DOORS

American Pro Decor assumes no liability for improper installation.

Summary of content (4 pages)

PAGE 1
HARDWARE KIT FOR SLIDING SINGLE WOOD DOORS MODEL No. INSTALLATION MANUAL 5APD10753 A D C F E G H I J K L B INCLUDED IN KIT TOOLS REQUIRED A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 8mm Drill Bit • 10mm Routing Drill Bit • Wrench • Level • Tape Measure • Power Drill E F G H I J K L Door Roller Hardware x2 96" Rail x1 Wall Bracket x6 2.5mm Allen Key x1 Door Stop x2 Anti-Jump Disk x2 Routed Floor Guide x1 Floor Anchor x2 ST4.
PAGE 2
Wall Blocking NOTES Suggested wall bracket spacing. Minimum door overlap on guide is 4-3/4" Brackets must be secured into wall blocking. To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. Consult a structural engineer if you have questions about what type of wall blocking is required. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long.
PAGE 3
Drill out holes in the door using a 10mm routing drill bit as pictured. The bottom of the door should be routed at this time in order to accept the floor guide. Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident. Attach the anti-jump disks to the tops of the door. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 4
Adjust the door stops accordingly using the provided 2.5mm Allen key. American Pro Decor assumes no liability for improper installation.