Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareBlack Solid Steel Sliding Rolling Barn Door Hardware Kit for Double Wood Doors With Non-Routed Adjustable Floor Guides

TOOLS REQUIRED

INCLUDED IN KIT

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 10mm Drill Bit

• 10mm Routing Drill Bit

• 5.5mm Drill Bit

• Wrench

• Level

• Tape Measure

• Power Drill

F G H

J K

Door Roller Hardware x4

M8x60 Bolt x9

M8x30 Wall Anchor x9

Wall Bracket x9

M8x90 Bolt + Washer x9

Optional Routed Floor Guide x2

Floor Anchor x4

ST4.2x25 Screw x4

Door Stop x4

2.5mm/4mm Allen Keys x1

Anti-Jump Disk x4

Non-Routed Floor Guide Set x2

68-7/8" Rail x2

American Pro Decor assumes no liability for improper installation.

MODEL No.

5APD10763

INSTALLATION MANUAL

HARDWARE KIT

FOR SLIDING DOUBLE WOOD DOORS

Summary of content (5 pages)

PAGE 1
HARDWARE KIT FOR SLIDING DOUBLE WOOD DOORS MODEL No. INSTALLATION MANUAL 5APD10763 A B F GH E I C D J K L M INCLUDED IN KIT TOOLS REQUIRED A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 10mm Drill Bit • 10mm Routing Drill Bit • 5.5mm Drill Bit • Wrench • Level • Tape Measure • Power Drill E F G H I J K L M Door Roller Hardware x4 M8x60 Bolt x9 M8x30 Wall Anchor x9 Wall Bracket x9 M8x90 Bolt + Washer x9 Optional Routed Floor Guide x2 Floor Anchor x4 ST4.
PAGE 2
NOTES Wall Blocking To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. Consult a structural engineer if you have questions about what type of wall blocking is required. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
PAGE 3
Join the two rails together. Fasten the door stops to the rail at this time, two in the center, two at each end. Attach the rail to the wall brackets using a wrench to fasten the bolts. Drill holes in the top of the door 4" from the edge as pictured to accommodate the door rollers. Attach the anti-jump disks to the tops of the doors. American Pro Decor assumes no liability for improper installation.
PAGE 4
Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident. Plumb the doors and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 5
Adjust the door stops accordingly using the provided 2.5mm Allen key. American Pro Decor assumes no liability for improper installation.