Instructions / Assembly

3D WOOD

WALLSCAPES

TOOLS REQUIRED FOR INSTALLATION

Electric Circular Saw Adhesive Gun

Step LadderTape Measure Finishing NailsPneumatic Hammer

100% PU Glue

Level

Electric Drill

3D Wood Wallscapes must be installed according to the installation guide and maintained in an environment

where the humidity is between 35% and 60%. Do not install the panels in bathrooms, shower rooms, or other

rooms exposed to excessive moisture. Allow 48-72 hours for the panels to acclimate to room temperature.

The application surface should be clean and dry.

ADHESIVE

PAGE 1
3D WOOD WALLSCAPES ADHESIVE TOOLS REQUIRED FOR INSTALLATION Electric Circular Saw Adhesive Gun 100% PU Glue Electric Drill Pneumatic Hammer Level Tape Measure Finishing Nails Step Ladder 3D Wood Wallscapes must be installed according to the installation guide and maintained in an environment where the humidity is between 35% and 60%. Do not install the panels in bathrooms, shower rooms, or other rooms exposed to excessive moisture.
PAGE 2
INSTALLATION PREPARATION Remove all accessories. moulding and electrical outlets from the wall where the product is to be installed. Ensure that the surface to be covered with 3D Wood Wallscapes is firm an leveled. Uneven areas must be adjusted. If necessary, remove loose paint using a painter’s knife. Optionally, a 3/8” thick plywood can be applied over the drywall if the wall is in poor condition. Clean and wipe the wall dry. Before installing, plan the placement of each panel.