Use and Care Manual

Installation Instructions Section 3
3-4
Final Installation
Sliding the Appliance into the Cabinet
Make sure that the gas supply and electrical service are properly connected.
Peel the protective coating off the appliance, if applicable.
Carefully slide the appliance into position in the cutout. The left rear leg should engage the anti-tip bracket.
Leveling and Adjusting the Appliance
Raise or lower the range until it is the same height as the countertop. To adjust the height, turn the bottom of the leg.
Use a level to make sure that the appliance does not tilt to the front/back or to either side.
Re-installing the Oven Door
Grasp both sides of the oven door and hold it at a 15 degree angle for the front of the appliance.
Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge openings.
While continuing to hold the door at a 15 degree angle, press in on each of the bottom corners of the door. Press until
the notch on the bottom of each hinge slips over the lower lip of each hinge opening.
Lower the door to the fully opened position.
Rotate the hinge locks toward the oven.
Slowly and open and close the oven door completely to ensure that it is properly reinstalled.
Installing the Burner Components
Install the burner components as shown.
Installation Check List
Has the appliance been installed using the anti-tip bracket?
Is the appliance level and all of the leveling legs making contact with the floor?
Is the appliance electrical service grounded in accordance with all applicable electrical codes?
Has the gas supply been installed in accordance with all applicable codes?
Have all gas supply connections been check for leaks?
Has the oven door been installed in accordance to these instructions?
Are all burners and grates properly installed?
Before Using the Appliance
Prior to operating this appliance, please read the operation and maintenance sections of this
manual.
Before beginning the test procedure, verify that all cooktop control knobs are in the OFF
position. Turn on the gas supply at the manual shut-off valve.
Turn ON each cooktop burner separately by pushing in the control knob and turning it counterclockwise to the
HIGH position. It may take a few seconds for ignition to occur. After ignition, rotate the control knob counterclockwise from
HIGH to LOW to adjust the flame.
Turn the control knob to the OFF position.
To set the time of day press the clock button, adjust the clock by press the time UP and Down buttons.
Press the BAKE button.
Adjust the temperature to 375 degrees using the UP and Down TEMP buttons.
The display should show BAKE, and the preheating temperature.
Press the OFF button to stop the oven preheating process.
If either the cooktop or oven does not operate properly, do not attempt to repair the appliance yourself.
American Range Corporation is not responsible for service required to correct a faulty installation.