Instructions / Assembly

2
Fill the spa.
Remove the cartridge from lter canister.
Soft water makes it impossible to maintain
the proper water chemistry and may cause
the water to foam, which will ultimately harm
the nish of the spa and void your warranty.
After you remove the lter, remove the plastic
wrapper and soak it in water for 30 minutes
before you replace it. A dry lter can allow air
into the ltration system which can cause the
pump to fail to prime.
If you have a skimmer like this:
Grip the lter by the handle and unscrew it from
the canister. Never try to pull the lter cartridge
while the spa is running in low or high speed (i.e.,
any speed).
If you have a skimmer like this:
Remove the black skimmer cap and barrel, grip the
lter by the handle and unscrew it from the canister.
If you have a skimmer like this:
Rotate and remove the black locking ring. Remove
the black skimmer cap and barrel, grip the lter
by the handle and unscrew it from the canister.
Replace and lock the locking ring and slide the
skimmer cap and barrel back in the canister.
Note: The skimmer cap and barrel were locked
in place at the factory to prevent damage during
shipment. It must be unlocked and replaced in
the lter canister so that it can oat when the spa
is lled. If you do not remove the cap and barrel,
your spa’s ltration system will not perform as it was
designed to.
Place a garden hose in the lter canister and ll
your spa. Always ll the spa through the lter
canister. Failure to do so may cause air to be trapped
in the ltration system and prevent the pumps from
operating properly.
Fill the spa until water level is about six inches from
the top. If the water level is too low or too high, your
spa will not operate properly. Never ll your spa
with soft water.
Teleweir Mega
lter skimmer
• 75 square feet
ltration
• Smooth cap
Teleweir lter
skimmer
• 50 square feet
ltration
• Spoked cap
2
3