Full Product Manual

American Spa Owner’s Manual
LTR50001143, Rev. M
Preparing for Your New Portable Spa
9
5. Prime the pump.
4. Turn on power to the spa.
Your spa will perform a self-diagnostic check and go into
Priming Mode. The control panel will display either RUN
PUMPS PURG AIR --- or Priming Mode, depending on
which control panel you have.
Do the following:
1. Press the JETS or JETS 1 button once to start the pump
in low speed.
2. Press it again to switch the pump to high speed.
3. If you have other pumps, press JETS 2 or JETS 3 to
turn them on also.
Running the pumps helps the pumps prime.
When the spa is lled to the correct level, turn on the
power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
After two minutes, the pump should prime. If it does not, follow the priming instructions on the next page. If it
does, continue with the next step.
Starting Up: Priming Mode for Neo-Pack Systems
The system will enter the priming mode. Priming Mode will display
on the control panel. In Priming Mode, all devices such as jets and
lights are operable. Jets can be turned on and off to help prime the
pump. The system will exit Priming Mode and go to the Main display
when the RETURN button is pressed, or after four minutes of activity.
Exiting Priming Mode for Neo-Pack Systems
You can manually exit Priming Mode by pressing the RETURN button.
Note that if you do not manually exit the priming mode, the priming
mode will be automatically terminated after 4 to 5 minutes. Be sure
that the pumps have been primed by this time.