Use and Care Manual

American Spa Owner’s Manual
LTR50001143, Rev. A
Operating Your Spa
10
When rst powered up, your hot tub will perform
a self-diagnostic check and go into priming mode.
When the control panel displays PR, IMMEDIATELY
do the following:
Press the JETS 1 button to turn on the pump 1.
and let it run for 10 seconds. The pump should
be running in low speed.
Press the JETS 1 button again and let the pump 2.
run in high speed for 10 seconds.
Press the JETS1 button again to turn off the 3.
pump. The pump should be left in the off
position for 10 to 15 seconds.
Repeat steps 1 through 3 until water is owing 4.
through all the jets and all air is removed from
the plumbing.
When the hot tub has nished priming, the heater
will be activated and the water temperature will
be maintained in standard mode. The hot tub will
heat to 100°F (37.5°C) at start up until the set
temperature is changed as described below.
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water
temperature in degrees Fahrenheit. The displayed
temperature will only be current after the pump has
been running for at least two minutes.
To display the temperature that the hot tub is set
to:
Operating Your Spa
Electronic Control Operation
Initial Start up
Temperature Adjustment
Standard, Economy and Sleep
Heating Modes
Your new hot tub is equipped with a heating feature
that gives you complete control of the heating system.
When the hot tub is powered up, it will automatically
start in standard heating mode.
St• will light briey on the main display. In this
mode, the heating system will automatically
maintain the set temperature. In the economy-
heating mode, the heating system will only activate
during ltration times.
Ec• will display solid if temperature is not current
and will alternate with water temperature if
measured temperature is current.
E• conomy mode will heat the water to the set
temperature while Sleep mode, indicated by a
SL on the main display, will also only activate
the heater during the ltering cycles but will only
heat the water to within 20°F (10°C) of the set
temperature. Like Economy mode, SL will display
Press the
• Temp button. The temperature setting
will ash.
While the display is ashing, each time you press •
Temp button, the set temperature will change up
or down one degree.
If the desired temperature is opposite of the •
direction each press of the button is making,
release button, allow display to stop ashing and
then press Temp button to change temperature
the other direction.