Full Product Manual

American Spa Owner’s Manual
LTR50001143, Rev. M
Operating Your Spa
12
When rst powered up, your hot tub will perform
a self-diagnostic check and go into priming mode.
When the control panel displays PR, IMMEDIATELY
do the following:
1. Press the JETS 1 button to turn on the pump
and let it run for 10 seconds. The pump should
be running in low speed.
2. Press the JETS 1 button again and let the pump
run in high speed for 10 seconds.
3. Press the JETS 1 button again to turn off the
pump. The pump should be left in the off
position for 10 to 15 seconds.
4. Repeat steps 1 through 3 until water is owing
through all the jets and all air is removed from
the plumbing.
When the hot tub has nished priming, the heater
will be activated and the water temperature will
be maintained in standard mode. The hot tub will
heat to 100°F (37.5°C) at start up until the set
temperature is changed as described below.
Operating Your Spa
Electronic Control Operation
Initial Start-up
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water
temperature in degrees Fahrenheit. The displayed
temperature will only be current after the pump has
been running for at least two minutes.
To display the temperature that the hot tub is set to:
• Press the Temp button. The temperature
setting will ash.
• While the display is ashing, each time you
press Temp button, the set temperature will
change up or down one degree.
• If the desired temperature is opposite of the
direction each press of the button is making,
release button, allow display to stop ashing and
then press Temp button to change temperature
the other direction.
For one pump systems
For two pump systems