Full Product Manual

American Spa Owner’s Manual
LTR50001143, Rev. M
Operating Your Spa
22
Cover Latches
When your hot tub is not in use, make sure you place the cover on top and latch it securely. Besides protecting
your hot tub from sun damage and keeping out contaminants, it will prevent small children from drowning in
the hot tub.
Your cover will have four clips attached to the ends of the four latches, two on each end of the hot tub cover.
There will also be a small bag with eight wood screws.
After you place the cover on the hot tub, attach the clips to the side of the hot tub using the wood screws.
Your spa may include two to eight streamer waterfalls. When the booster
pump is on, turn the 1” diverter knob to adjust the rate of ow to the
waterfall jets.
The waterfall jet faces are not adjustable. Do not turn the jet faces
because you may accidentally remove them.
Always shut off water to the hydro streamer jets before you place the cover
on the spa. Water from the hydro streamer jets sprays in an arc that is
higher than the top surface of the spa. When water from
the hydro streamer sprays the bottom of the cover, it
will collect and run to the edge of the spa
and drip over the top.
Waterfall
Hydro Streamer Waterfall
Some spa series include a waterfall. When the booster
pump is on, rotate the dial on top (for the cascade
waterfall) or turn the knob (for the hydro streamer --
see below).