Use and Care Manual

LTR17000972_ASC, Rev. A 3/13/18

Prime the pump.

Turn on power to the spa.

When the spa is lled to the correct level, turn on the power at

the GFCI breaker. (Ensure that the 120V spas are connected to the

properelectricaloutlet.)

Jets

Aux Warm Cool Light

(auxiliaire)

(chaud)

(froid)

(lumière)

Running the pumps helps the pumps prime.

After two minutes, the pump should prime. When it does, continue with the next step. If the

pump does not prime, follow the priming instructions on the next page.

For VS300 and 5100 systems:

Your spa will perform a self-diagnostic check

and go into priming mode, which is indicated by

message Pr on the control panel.

Do the following:

a. Press the JETS button to turn on the pump

and let it run for 10 seconds. The pump

should be running in low speed.

b. Press the JETS buttons again and let the

pump run in high speed for 10 seconds.

c. Press the JETS button again to turn off the

pump. The pump should be left off for 10 to

15 seconds.

d. Repeatstepsathroughcuntilwaterisowing

through all the jets and all air is removed from

the plumbing.