Installation Guide

1
791615-100
Recommended Tools & Materials
NEW SALEM 0255.112 / 0255.212
NEW SOLAR 0263.112 / 0263.212
Enameled Steel Bath
INSTALLATION INSTRUCTIONS
CAUTION: RISK OF PERSONAL INJURY. ENAMELED STEEL BATHS ARE HEAVY.
THIS IS A TWO PERSON INSTALLATION.
!
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read
these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
• Tape Measure
• Level
• Square
• Pliers
• Pipe Wrench
• Hacksaw
• Hammer
• Drywall Screw
• Teflon Tape
• Silicone Sealant
• Screwdriver
• Shims
• Bath/Shower Faucet
• Drain Assembly
• Wall Coverings, As Needed
ROUGH-IN DIMENSIONS
DETERMINE FRAMING ROUGH-IN
Construct a recess using 2 x 4 construction designed
for your particular installation. Allow for thickness of
finished wall material.
-1-
NOTE: Measurements may vary plus or minus 1/4" (6mm).
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2014
LEFT HAND TUB ILLUSTRATED
RIGHT HAND TUB IS REVERSED
3/4"
(19mm)
C/L OF
SUPPLIES
1-1/2 O.D.
TAILPIECE
2-1/4"
(57mm)
8"
(203mm)
FINISHED
WALL
C/L OF
DRAIN
60"
(1524mm)
3-1/2"
(89mm)
3/4"
(19mm)
30"
(762mm)
3/4"
(19mm)
SEE FAUCET SPECS
FOR DIMENSION
C/L OF
SPOUT
4"
(102mm)
1"
(25mm)
12"
(305mm)
3-1/4"
(83 mm)
SUB
FLOOR
FINISHED
WALL
C/L OF
SHOWER ARM
PROVIDE SUITABLE
SUPPORT AT THIS POINT
C/L OF
VALVES
SUMP PAD
*0255 - 14-1/4" (362mm)
*0263 - 16-5/8" (422mm)
OPTIONAL TO FINISHED FLOOR
[USUALLY BETWEEN
65" & 78"
(1651mm & 1981mm)]
1-1/2" (38mm) O.D.
TAILPIECE (Not supplied)
14-1/2"
(368mm)
2-3/4"
(70mm)
*
30"
(762mm)
60-1/8"
(1527mm)
14-1/2"
(368mm)
32
"
(
813mm)
TYP.
TUB WIDTH
LEVELED SUPPORT
STRINGER
*0255 - 14-1/4" (362mm)
*0263 - 16-5/8" (422mm)
*