Installation Guide

2
Install lavatory anchor
screws leaving 1-7/8"
threaded end exposed
as illustrated.
Following manufacturer's
instructions, install faucet
and drain assembly (not
included). Be certain to
apply a bead of sealing putty
on the underside of the drain
(area "A") in order to ensure
a watertight seal between the
lavatory and drain. Remove
excess putty after installing
drain on lavatory.
7
Secure lavatory to wall as
shown in 5 or 5a. Install
washers and hand tighten
nuts or lag bolts.
Level and square the unit.
Connect hot and cold supply
lines to the shut-off valves.
Tighten trap joints for water-
tight assembly.
8
Install pedestal screws.
Securely tighten lavatory
anchor nuts or lag bolts.
alignment. It may be ne-
cessary to cut off part
of the tailpiece (area "B")
and/or part of the drain
elbow of the trap (area "C").
3
Mark lavatory and pedestal screw locations through the
mounting holes. If a steel hanger is supplied mark the location
of its screws when positioned as shown in step 5a.
4
5
6
Approx. Bumper
locations to raise
the lavatory slab
left side.
Top of Pedestal
1-7/8"
B
C
Shut-Off
Valves
Rear
View
Pedestal
Screws
730235-100 Rev. F
Return the fitted lava-
tory and pedestal to the
installed position. Con-
nect trap to drain assem-
bly hand tight to check
A
ANCHOR SCREW
INSTALLATION
5a
Use lag bolts to secure
lavatory as illustrated.
LAG BOLT
INSTALLATION
Anchor
Screw
Washer
Lavatory
Nut
Lag
Bolt
Washer
Lavatory
Lavatory
Steel
Hanger
IMPORTANT: Final assembly of nut and washer or lag bolt method
shown for reference only. (See steps 8 and 9).
Place lavatory and pedestal
into installed position. Level
and square the lavatory and
pedestal assembly. Use one
or more bumper cushions
(supplied) to level and
cushion lavatory slab to
pedestal.
For example only
9
Note: Space constraints may
dictate method of fastening
pedestal to floor.
Remove lavatory and pedestal from
installed position. Drill pilot holes
for lavatory and pedestal anchor
screws or lag bolts. Note: Some
models are supplied with lag bolts,
anchor screws, or steel hangers
for lavatory installations only. Other
models and all pedestals are not
provided with mounting hardware.
Various pedestal screw sizes and
types are available to the installer
at local hardware outlets.