Installation Guide

2
7302307-100
5
1-7/8"
ANCHOR SCREW INSTALLATION
Anchor
Screw
Washer
Lavatory
Nut
IMPORTANT: Final assembly of nut and washer or lag bolt method shown for reference only.
6
A
9
Rear
View
7
B
C
Note: Space constraints
may dictate method of
fastening pedestal to floor.
4
Remove lavatory and
pedestal from installed
position. Drill pilot holes for
lavatory and pedestal
anchor screws or lag bolts.
Note: Some models are supplied with lag bolts, anchor screws, or
steel hangers for lavatory installations only. Other models and all
pedestals are not provided with mounting hardware. Various
pedestal screw sizes and types are available to the installer at
local hardware outlets.
1
Provide suitable reinforcement
behind finished wall for lavatory
mounting screws.
*
Determine horizontal center line
location of support from fixture.
NOTE: If replacing an existing sink
be certain to shut off water supply
before removing old sink.
C/L of 2X6
Support
Finished
Floor
*
3
Mark lavatory and pedestal screw locations through
the mounting holes.
2
Top of Pedestal
For example only
Place lavatory and pedestal into installed position.
Level and square the lavatory and pedestal assembly.
8
Secure lavatory to wall as
shown in Step 5. Install
washers and hand tighten nuts
or lag bolts. Level and square
the unit. Connect hot and cold
supply lines to the shut-off
valves. Tighten trap joints for
watertight assembly.
Following manufacturer's
instructions, install faucet and
drain assembly (not included).
Be certain to apply a bead of
sealing putty on the underside
of the drain (area "A") in order
to ensure a watertight seal
between the lavatory and drain.
Remove excess putty after
installing drain on lavatory.
Return the fitted lavatory to the
installed position. Connect trap to
drain assembly hand tight to check
alignment. It may be necessary to
cut off part of the tailpiece (area
"B") or part of the horizontal leg of
the trap (area "C").
Lavatory slab
Install lavatory anchor screws leaving 1-7/8"
threaded end exposed as illustrated.
Shut-Off
Valves
Use lag bolts to secure lavatory as illustrated.
LAG BOLT INSTALLATION
Lag
Bolt
Washer
Lavatory
Lavatory
Steel
Hanger
ALTERNATE METHOD: COMPONENTS NOT INCLUDED