Specification

© 2004 American Standard Inc.
CI-59
CORNER MINETTE™
WALL-HUNG LAVATORY
VITREOUS CHINA
CORNER MINETTE WALL-HUNG LAVATORY
• Vitreous china
• Front overflow
• Supplied with 2 wall hangers
• Faucet ledge.
Shown with 2000.101 Ceramix faucet
(not included)
❏ 0451.021
Faucet holes on 102mm (4") centers
❏ 0451.001
Single center faucet hole
Nominal Dimensions:
279 x 425mm
(11" x 16-3/4")
Bowl sizes:
311mm (12-1/4") wide,
219mm (8-5/8") front to back,
133mm (5-1/4") deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2 for Vitreous China Fixtures
To Be Specified
❏ Color: ❏ White ❏ Bone ❏ Silver
❏ Fawn Beige
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies with Stop:
❏ 1-1/4" Trap:
❏ Nipple:
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE SUGGESTED.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances
established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is assumed for use
of superseded or voided pages.
* See faucet section for additional models available
FINISHED
FLOOR
SUPPLIES
AS REQ'D.
464mm
(18-1/4)
*
178mm
(7-1/2)
165mm
(6-1/2)
279mm
(11)
165mm
(6-1/2)
152mm
(6)
127mm
(5)
102mm
(4)
127mm
(5)
425mm
(16-3/4)
C/L OF C.W. SUPPLY
C/L OF WASTE
C/L OF HANGER
FINISHED WALL
(2)19mm(3/8) DIA. ANCHOR SCREW
HOLES IN BACK DRAPERY
HANGER
260mm
(10-1/4)
*
178mm
(7)
178mm
(7)
787mm
(31)
108mm
(4-1/4)
1-1/4 O.D WASTE
1-1/4 O.D. TAILPIECE
C/L OF HANGER
C/L OF H.W. SUPPLY
Revised 9/04
NOTE: Additional roughing-in information shown
on reverse side of page