Specification Sheet

J16
© 2014 AS America Inc.
Rev. 2/14
EVOLUTION
®
22"
PEDESTAL SINK
VITREOUS CHINA
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼ ANCHOR SCREWS FOR PEDESTAL NOT INCLUDED.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
■ SUITABLE FOR REINFORCEMENT ONLY, ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
1-1/4" O.D.
WASTE
1-1/4" O.D.
TAILPIECE
SUPPLIES
AS REQ'D
3 x 1-3/8"
(35mm)
DIA
2-1/2"
(63mm)
22"
(558mm)
7-7/8"
(200mm)
17-1/2"
(444mm)
1-3/4"
(44mm)
2-1/2"
(64mm)
FINISHED
WALL
SIDE VIEW
27-5/8"
(702mm)
OPEN TO
FLOOR
FRONT VIEW
BACK VIEW
6-1/2"
(166mm)
8"
(203mm)
34-1/4"
(870mm)
31-1/4"
(794mm)
6-1/4"
(158mm)
7"
(178mm)
7"
(178mm)
C
L
22"
(558mm)
3-1/8±1/4"
(78±5mm)
7-1/8±1/4"
(180±5mm)
REF.
HOLES FOR
ANCHOR BOLTS
23"
(584mm)
20-1/2"
(521mm)
8-1/8±1/4"
(210±5mm)
To Be Specied:
❏ Color: ❏ White ❏ Bone ❏ Linen
❏ Faucet:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
EVOLUTION
®
22" PEDESTAL SINK
 •Vitreouschinalavatoryandpedestal
 •Rearoverow
 •Faucetledgewithgenerousshelfarea
 •Suppliedwithmountingkit
❏ 0467.100 Faucet holes Center Hole only
❏ 0467.40 0 Faucet holes on 4" (102mm) centers
❏ 0467.800 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
22" x 17-1/2" x 34-1/4"
(558 x 444 x 870mm)
Separate Components:
❏ 0467.001 Pedestal top Center Hole only
❏ 0467.004 Pedestal top 4" (102mm) centers
❏ 0467.008 Pedestal top 8" (203mm) centers
❏ 731150 - 400 Pedestal only
Bowl sizes:
18-1/4" (464mm) wide
11"(279mm)fronttoback
6" (152mm) deep
Compliance Certications -
Meets or Exceeds the Following Specications:
•ASMEA112.19.2MforVitreousChinaFixtures