Installation Guide

ManualsBrandsAmerican Standard ManualsBathOvalyn Front Overflow Undercounter Bathroom Sink with Glazed Underside in White

730431-100 Rev. F

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

INSTALLATION INSTRUCTIONS

Undercounter Sink

Oval Shaped Models: 0495, 0496, 0497, 0630, 0632

Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help

ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review

the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

Product names listed herein are trademarks of AS America, Inc.

Recommended Tools & Materials

Observe Local Plumbing and Building Codes.

Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.

Adjustable Wrench Channel Lock Pliers

Regular Screwdriver

Phillips Screwdriver

10'

Pipe Wrench

Putty Knife

Silicone Adhesive

Basin Wrench

Plumbers' Putty

Tubing Cutter

Tape Measure

Hacksaw

Saber Saw

1 2

Perimeter of sink

Cutout

NOTE: More specialized tools may be necessary to install this sink

to countertop materials other than wood or wood composites.

NOTE: To avoid damage to

countertop, install sink such that

future removal from underneath

the countertop is possible.

First, make sure the clearance

between the backsplash, faucet,

fixtures and cabinets are

acceptable for the new sink.

Carefully cut out the enclosed

template, then position and

trace the template on the

countertop as shown on the

template. Make a mark of the

faucet hole centerline on the

countertop. Drill a 1/2" pilot

hole on the inside of the cut

line. Use a saber saw or a

keyhole saw to cut out the

countertop opening.

Drill

Drill 1/8" dia. x 3/8" deep

#10 Wood Screw

Clip

Mark and pre-drill the wood screw holes as located on the

enclosed template. Waterproof any exposed areas of wood.

FOR WOOD COUNTERTOP

FOR MARBLE OR SOLID SURFACE COUNTERTOP

1/2" (13mm) MIN.

Clip

Brass insert, epoxy

in place with threaded

end exposed.

(Epoxy not supplied).

#10-32 Mach. screw

snug in place

To protect countertop, place it on a foam padding and drill

3/8" Dia. x 1/4" deep hole as per location shown on template.

Clean countertop surface and sink surface where silicone

caulking/adhesive is applied.

Clean surfaces and apply

silicone caulking/adhesive.

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Undercounter Sink Oval Shaped Models: 0495, 0496, 0497, 0630, 0632 Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture. ! CAUTION: PRODUCT IS FRAGILE.
PAGE 2
5 A Mount the drain assembly (not included) on the sink, following faucet manufacturer's instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink. 7 Center bowl over cutout and tighten screws (see step 4) to secure bowl to countertop. Remove excess sealant from inside lip.