Installation Guide

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
ABOVE COUNTER VESSEL
CELERITY 0514.000
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
!
7301370-100
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife Regular Screwdriver Adjustable Wrench Drill Plumber’s Putty or Caulking
Tape Measure Phillips Screwdriver Pipe Wrench Basin Wrench Channel Lock Pliers
Tubing Cutter Jig Saw Silicone Adhesive Hacksaw
1A
2
3
Perimeter
of cut out
Perimeter
of cut out
1B
A
Locate the position of the vessel as required. Provide proper
clearance under the countertop for the faucet supply lines,
drain assembly and the structural parts of the cabinet.
NOTE: If replacing an existing vessel be certain to shut off
water supply before removing old vessel.
Wall-mount faucet installations:
Ensure sufficient spout overhang into the vessel. See
manufacturer’s installation instructions and roughing-in notes
for minimum spout lengths.
Countertop faucet installations:
Locate the faucet hole on the countertop. Allow 1" minimum
clearance between:
• the vessel and faucet
• the backsplash and faucet
Use the faucet installation instructions for required clearances.
Drill a clearance hole
inside the perimeter of
the cut out.
Cut opening around the
perimeter of the cut out.
NOTE: For Wallmount or
Countertop faucets, drill
faucet holes according to
manufacturer’s instructions.
Mount the faucet and drain assembly (not included) on
the countertop following the manufacturer’s instructions.
Be certain to apply a bead of sealing putty on the
underside of the drain (Part “A”) in order to ensure a
watertight seal between the vessel and drain. Remove
excess putty after installing drain on vessel.
Rear Faucet
(4" minimum)
8-1/2"
(216mm)
17"
(432mm)
Adhesive
Bond
Countertop
(by others)
Supplies
(as required)
Finished
Wall
Cut Out
Countertop
8-1/2"
(210mm)
Dia. Hole
(210mm)
8-1/4" Dia.
(210mm)
4"
(102mm)
30"
(762mm)
1-1/4" (32mm)
O.D. Waste
20"
(508mm)
18"
(457mm)
Finished
Floor
8"
(203mm)