Installation Sheet

- 5 -
7302028-101
5B
6
7
8
APPLY SEALANT
INSTALL COUNTERTOP
ASSEMBLE AND INSTALL P-TRAP AND DRAIN CONNECTIONS
INSTALL FAUCET
For Under Countertop Sinks:
Carefully wipe clean the sink apron and top rim free
from all debris. Ensure that the surface on underside
of countertop cutout opening is smooth and free of
debris. Under countertop installation requires a generous
bead of sealant around the sink top rim where sink and
countertop underside will make contact.
Carefully position and install the countertop. Ensure the sealant provides a complete seal between the sink and
the countertop surface. Fill any voids and wipe excess away with soft damp cloth.
Assemble and install P-trap drain connections in
accordance with manufacturer’s instructions. Connect
trap to drain assembly hand tight to check alignment.
It may be necessary to cut off part of the tailpiece
(area “B”) or part of the horizontal leg of the trap
(area “C”). Secure joints for watertight assembly.
Carefully locate and install faucet to countertop in accordance with manufacturer’s instructions.
Ensure you provide adequate clearance for supply lines and faucet operation.
Connect supply lines to shutoff valves. Turn on water supply valves and water-test installation.
TOP OF CABINET
APPLY SEALANT
ON TOP THREE
SIDES OF RIM
B
C
5A
APPLY SEALANT
For Flush Mount Sinks:
Carefully wipe clean the sink apron and top rim free
from all debris. Ensure that the surface on underside
of countertop and around the countertop cutout
opening is smooth and free of debris. Flush mount
installation requires a generous bead of sealant around
the sink apron where sink and countertop will meet.
APPLY SEALANT
THREE SIDES
TOP OF CABINET
NOTE: P-trap, drain connections and faucet are not included.