Center Set Faucets Installation Instructions

Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE

SUPPLIES (1) or 3/8" O.D. BULL-NOSE RISERS (2).

Use adjustable wrench to tighten connections. Do not over

tighten. Be careful not to kink copper supply when bending.

Use tubing cutter to cut to proper length.

MAKE WATER SUPPLY CONNECTIONS

Plumbers' Putty or CaulkingAdjustable WrenchChannel Locks

TOOLS REQUIRED

INSTALL FAUCET

1340.225

1340.255

1340.265

Certified to comply with ANSI A112.18.1

Thank you for selecting American-Standard...the

benchmark of fine quality for over 100 years.

To ensure that your installation proceeds

smoothly--please read these instructions carefully

before you begin.

Installation

Instructions

METERING

Center Set Faucets

FERRULE

COUPLING NUT

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE

PURCHASED SEPARATELY.

Insert faucet SHANKS through holes of SINK or

MOUNTING SURFACE.

Install GASKET (2), FRICTION WASHER (3), DEEP

WASHER (4) and LOCK NUT (5). onto SHANKS (6).

Tighten LOCK NUTS (5) firmly to secure FAUCET (1).

Apply a bead of PUTTY along the edge of the

underside of the FAUCET (1).

SINK OR

MOUNTING

SURFACE

PUTTY

SHANK

Turn off hot and cold water supplies before beginning.

CAUTION

1340.225 1340.255 1340.265

2.5mm Hex Wrench

PAGE 1
Installation Instructions METERING 1340.225 1340.255 1340.265 Center Set Faucets Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. 1340.225 1340.255 To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. 1340.265 Certified to comply with ANSI A112.18.1 TOOLS REQUIRED Channel Locks Adjustable Wrench Plumbers' Putty or Caulking 2.
PAGE 2
! # TEST INSTALLED FITTING SERVICE Turn on water supplies and check connections for leaks. Remove HANDLE (1). Refer to Step 4 for handle removal. Remove AERATOR (1) with KEY (2) supplied. Remove ACTUATOR ASSEMBLY (2). Operate HOT and COLD HANDLES by pressing down on HANDLES. Both Hot and Cold handles are set for approximately 8 second operating cycles. Remove WASHER (3). Pull out VALVE ASSEMBLY (4) and FILTER SCREEN (5).
PAGE 3
METERING Center Set Faucets PRODUCT NUMBERS 1340.225 5" GN 1340.255 6" GN 1340.265 M962390-YYYOA HANDEL KIT M962391-0070A INDEX KIT M952200-YYY0A ACTUATOR UNIT Replace the "YYY" with appropriate finish code M962392-0070A VALVE KIT CHROME 002 M913860-0070A WASHER M952210-0070A VALVE M952220-0070A FILTER SCREEN M962393-YYY0A 1.