User Guide

ManualsBrandsAmerican Standard ManualsBathroom FixturesAmerican Standard 1340.105.002 Pillar Tap Metering Faucet, Chrome

M 9 6 8 4 9 7 R E V. 1.4

Certiﬁed to comply with ANSI A112.18.1M

Turn off hot and cold water

supplies before beginning.

CAUTION

FAUCET INSTALLATION (With optional 4" Deck Plate)

SPOUT

RECESS

APPLY PUTTY

MOUNTING

SURFACE

COLD WATER

OR TEMPERED

WATER SUPPLY

3/8" COMPRESSION

PILLAR TAP FAUCET

Installation

Instructions

Thank you for selecting American-Standard...the

benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

Note: Faucet can be installed as single hole installation or

with (OPTIONAL) 4" or 8" DECK PLATES. 4" No. 605P400

& 8" No. 605P800 Deck Plates must be ordered separately.

METERING

Plumbers' Putty or CaulkingAdjustable Wrench Phillips ScrewdriverChannel Locks

TOOLS REQUIRED

Tubing Cutter

Install SEAL (1) into base of FAUCET (2). Assemble Optional DECK PLATE (3), and PUTTY PLATE (4) to FAUCET BODY (2) with

SCREW (5). Apply a bead of putty to underside of PUTTY PLATE (3). Fig. 1a.

Insert FLEX HOSE (6) and SPOUT SHANK (7) through center hole of mounting surface. Fig. 1a.

Assemble "C" WASHER (8) and LOCKNUT (9) onto threads of SPOUT SHANK (7) from underside of mounting surface. Fig. 1b.

Align FAUCET (2) and tighten LOCKNUT (9). If installing DECK PLATE (3) hand tighten DECK PLATE SPIN NUTS (10) to secure

FAUCET (2) to mounting surface. Fig. 1b.

Fig. 1a

Fig. 1b

CONNECT WATER SUPPLY

Connect 3/8" compression coupling nut on ﬁtting supply hose to

cold water supply or tempered water supply.

1340.105

1340M.105

1340.109

1340M.109

1340.107

1340M.107

1340.119

1340M.119

Summary of content (2 pages)

PAGE 1
Installation Instructions METERING 1340.105 1340M.105 1340.109 1340M.109 1340.107 1340M.107 1340.119 1340M.119 PILLAR TAP FAUCET Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M 9 6 8 4 9 7 R E V. 1.
PAGE 2
3 TEST INSTALLED FITTING PRESS HANDLE DOWN TO OPERATE Turn on water supplies and check connections for leaks. 3 Remove AERATOR (1) with KEY (2) supplied. Operate FAUCET by pressing down on HANDLE (3). Handle is set for approximately 8 second operating cycle. 1 2 Replace AERATOR (1). 4 5 TO ADJUST CYCLE TIME Remove HANDLE (1) by removing INDEX BUTTON (2) and SET SCREW (3) with a 2.5mm hex wrench. Pull off HANDLE (1). To increase cycle time, turn the gray PLASTIC ADJUSTING NUT (4) clockwise.