Installation Guide

M 9 6 5 2 4 0 R E V. 1. 1
1
1
2
Turn off hot and cold water
supplies before beginning.
CAUTION
INSTALL SHOWER HEAD
APPLY SEALANT
OR TEFLON TAPE
BOTTOM EDGE
SHOULD BE LEVEL
Thread SHOWER HEAD (1) hand tight onto SUPPLY NIPPLE (2). FIG. 1.
Level SHOWER HEAD (1). Mark the location of the three mounting holes. Remove SHOWER HEAD (1). FIG. 2.
Drill three 1/8" diameter holes a minimum of 1-1/4" deep. With a hammer tap the three ANCHORS (3) (not supplied)
flush with face of the finished wall. FIG. 3.
Apply TEFLON TAPE (4) to SUPPLY NIPPLE (2). FIG. 4.
Thread SHOWER HEAD (1) onto SUPPLY NIPPLE (2). Use a strap wrench to protect finish. Fully tighten and check for level.
Turn shower on and check for leaks. Tighten if required. FIG. 5.
Install the MOUNTING SCREWS (5) (not supplied) and fully tighten to secure the SHOWER HEAD (1) to the wall. FIG. 5.
1
2
4
5
3
2
DRILL THREE 1/8"
DIAMETER HOLES
FIG. 1.
FIG. 2.
FIG. 3.
FIG. 4.
FIG. 5.