Installation Guide

- 3 -
6
7
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
5
M965796 (2/17)
SPRAY OPERATION
• With FAUCET on press TOGGLE
BUTTON (4) on SPRAY (3) to
switch from stream to spray.
• Press and hold PAUSE BUTTON (5)
to temporarily stop ow from
SPRAY (3). Release PAUSE
BUTTON (5) to resume ow
fromSPRAY (3).
SERVICE
TEST INSTALLED FAUCET
• Move HANDLE (1) into “off” position.
• Turn on water supplies.
• Check connection for leaks.
(See Section 4)
• With HANDLE (1) in “off” position,
unthread SPRAY (3) from HOSE (2).
• Operate handle back to front, in
COLD and HOT positions, to ush
water lines thoroughly.
• Replace SPRAY (3) onto HOSE (2).
1
3
2
REMOVE
ON
OFF
COLD
HOT
STREAM
(AERATOR)
SPRAY
5
3
4
3
4
5
5a
2
1
8
6
7
If faucet drips, operate HANDLE several times
from “off” to “on.” Do not apply excessive force.
Clogged CARTRIDGE outlets or inlets may
cause reduced flow.
To clean, rst turn off water supply then:
• Loosen HANDLE SCREW (1) and remove
HANDLE (2).
• Unthread ESCUTCHEON CAP (3) and
ADAPTER (8). Unthread three
MOUNTING SCREWS (4).
• Lift CARTRIDGE (5) off MANIFOLD (6)
and remove CARTRIDGE SEALS (7).
• Clean MANIFOLD (6), CARTRIDGE (5)
ports and SEALS (7).
• Place SEALS (7) into CARTRIDGE
PORTS (5a).
• Place CARTRIDGE (5) onto
MANIFOLD (6) tighten ADAPTER (8)
and tighten MOUNTING SCREWS (5)
alternately.
• Replace ESCUTCHEON CAP (4),
HANDLE (2), tighten HANDLE
SCREW (1).