Installation Guide

Installation

Instructions

Certiﬁed to comply with ANSI A112.18.1

Recommended Tools & Materials

ROUGHING-IN DIMENSIONS

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

M965241

Electric Drill

3mm (1/8")

Drill Bit

Pencil

Phillips Screwdriver

Hammer

COMMERCIAL 36" SLIDE/GRAB BAR

WITH HAND HELD SHOWER HOLDER

1662.236

41.5mm

(1-5/8")

914mm

(36")

954mm

(37-1/2")

FINISHED WALL

79mm

(3-1/8") DIA.

79mm

(3-1/8") DIA.

79mm

(3-1/8") DIA.

OPTIONAL TO FINISHED FLOOR

USUALLY BETWEEN

FINISHED

FLOOR

915mm

(36")

1525mm

(60")

PAGE 1
Installation Instructions COMMERCIAL 36" SLIDE/GRAB BAR WITH HAND HELD SHOWER HOLDER 1662.236 Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Recommended Tools & Materials 3mm (1/8") Drill Bit Phillips Screwdriver Hammer Electric Drill Certified to comply with ANSI A112.18.1 Pencil M965241 ROUGHING-IN DIMENSIONS 79mm (3-1/8") DIA.
PAGE 2
1 INSTALLATION INSTRUCTIONS The GRAB BAR (1) works best when secured to the wall studs or cross brace using WOOD SCREWS. If mounting into the studs is not possible, use appropriate wall fasteners provided to secure the installation. Mark a vertical center line in the location you wish to install the SLIDE BAR (1). NOTE: The height from the finished floor is optional. See rough-in drawing for suggested dimensions.