Installation Sheet

791640-100 Rev. A 11/17
- 5 -
6
5
7
4
Apply sealant to the rim of the sink near the inside edge.
Be careful not to miss or skip an area.
Apply silicone sealant.
Wipe away any excess sealant. Fill voids and allow to cure.
Lift the sink into place. Follow the instructions from your countertop supplier in order to tighten the mounting hardware evenly.
DO NOT OVERTIGHTEN
Countertop
Mount the faucet and strainer assembly following the
manufacturer's instructions.
!
Below
sink
NOTE: Your sink may not come with the strainer
and faucet assembly in which case you will need
to purchase separately and follow instructions
included with the purchased products.
A
B
Single Bowl
Tra p
Double Bowl
Tra p
Connect drain assembly hand tight to check alignment. It
may be necessary to cut off part of the tailpiece (area "A")
or part of the horizontal leg of the trap (area "B").
Secure joint for watertight assembly.
8
9
Connect supply lines to faucet finger tight, and
carefully bend to engage with the supply stops.
Tighten connections to faucet for secure seal.