Operating instructions

33
13-MAINTENANCE AND REPAIRS (continued)
2011 June
200a-NA
Refer to Figure 13-8 and adjust belt tension as follows:
1. Remove and retain center plate/front cover and four screws.
2. Loosen, but do not remove, M10 lock nut with a 17mm open-end wrench.
3. Reset the tension on the drive belts as needed. Adjust the M8 tension screws in (clockwise) to increase
tension or out (counterclockwise) to decrease tension. Tighten lock nut to secure tension setting.
4. Replace center plate/front cover and secure with original screws.
Figure 13-8
Box Drive
Belts
Infeed End
M6 Hex Wrench
M10 Lock Nut
Center
Plate
M5 X 16 Flat
Hd Screw (4)
M8 Socket Hd
Tension
Screw (4)