Instructions / Assembly

ManualsBrandsAmerican Standard ManualsBathEdgemere 2-Piece 1.28 GPF Single Flush Right Height Elongated Toilet in White, Seat Not Included

SAVE FOR FUTURE USE

7302406-100

Product names listed herein are trademarks of AS America, Inc.

Edgemere

2-piece Toilet

Elongated and Round Front

Models 204AA, 204BA Series

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read

these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

Wax Ring

Tank To Bowl Gasket

Slow Close Toilet Seat

Water Supply Line

Attachment Handle

with 2 Nuts

2 Plastic Washers

Bolt Caps (2)

Bowl-To-Floor

Knobs (2)

T-Bolts with

Retainer (2)

EZ-INSTALL KIT INCLUDED WITH TANK

TANK 4519A and 4519B

BOWL 3519A ELONGATED / BOWL 3519B ROUND FRONT

SOLD SEPARATELY

EZ-INSTALL KIT INCLUDED WITH BOWL

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS CARE AND MAINTENANCE Edgemere® 2-piece Toilet Elongated and Round Front Models 204AA, 204BA Series Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. ! CAUTION: PRODUCT IS FRAGILE.
PAGE 2
If Removing An Existing Toilet Before You Start: Turn Off Water Supply Flush to remove water from tank; sponge remaining water from bowl before removing toilet. Clean Flange ! Caution: If leaving floor flange open for more than 1-2 hours, cover flange to prevent escaping sewer gases. BACK-TO-BACK INSTALLATION Recommended fitting type for back-to-back installations.
PAGE 3
5 6 Install tank bolts in bottom of tank as shown. Tighten handles alternately until the tank contacts the front and back of the bowl achieving china-to-china contact. ! Tank to Bowl Gasket Place the tank gasket over the tank nut ensuring there are no gaps between the gasket and the chinaware. NOTE: To ease installation, push down on the top of the tank while tightening handles. 7 ! WARNING: Overtightening of water supply line nuts could result in breakage and potential flooding.
PAGE 4
9 DUAL FLUSH PUSH BUTTON ADJUSTMENTS FILL VALVE OR WATER CONTROL WATER LEVEL ADJUSTMENT KNOB REFILL TUBE SET WATER LEVEL HERE FLOAT CUP FLUSH VALVE a. Adjust water level. Water level should be adjusted to level indicated on tank by adjusting float cup using water level adjustment knob. b. Flush Valve Setting Adjustments: Flush Valve Setting Adjustments Without Liner Tank Full Flush Adjustment 2 Lite Flush Adjustment 2.
PAGE 5
* for SINGLE FLUSH Models ONLY * See Step 8 For Diagram Problem TROUBLESHOOTING GUIDE Possible Cause ** See Step 9 For Diagram Corrective Action a. Water supply valve closed. b. Supply line blocked. Does not flush ** for DUAL FLUSH Models ONLY a. Open valve and allow water to fill tank. b. Shut off water supply, disconnect supply line and inspect all gaskets and washers. Reassemble. *c. Readjust chain length as required. **c. Adjust rods per step 9 d. Shut off water supply.