Installation Sheet

7302406-100

- 2 -

BACK-TO-BACK INSTALLATION

Recommended fitting type for

back-to-back installations.

Depending upon your plumbing and venting conditions, the flow from the toilet in a back-to-back

installation may create a vacuum on the system and draw water from the opposing bowl. The

National Standards Plumbing Code prohibits the use of a cross fitting for drainage as throw over

is possible. The code does approve a directional "Y" style fitting with proper venting to direct the

water downward and away from the other toilet.

Press firmly.

NOTE: 1/4" EZ-BOLTS INCLUDED.

IF 5/16" BOLTS ARE REQUIRED,

PURCHASE SEPARATELY.

Wax Ring

(sold separately)

1 2

Turn Off Water Supply

Flush to remove

water from tank;

sponge remaining

water from

bowl before

removing toilet.

Clean Flange

Before You Start:

If Removing An Existing Toilet

Caution: If leaving ﬂoor ﬂange

open for more than 1-2 hours,

cover ﬂange to prevent escaping

sewer gases.

3 4

Apply weight evenly.

Do not move after

placement. Water

tight seal may break.

Hand tighten

only. Do not

overtighten.