Installation Guide

5
M965612 Rev. 1.7 (11/16)
ELECTRICAL INSTALLATION
Fig. 1a
Fig. 1b
Fig. 1
Fig. 1c
5a
7
2
Fig. 1d
2
3
1
4
5
INSTALL BATTERY
STANDARD
BATTERY
STANDARD
BATTERY
PWRX
PWRX
CR-P2
5a
5a
5a
6
5
A
DC VERSIONS (PWRX & STANDARD
BATTERY); Fig. 1
1. Remove CONTROL BOX COVER (1). Fig. 1.
2. Feed the SENSOR CABLES (2) through the top of
CONTROL BOX (3). Fig. 1a.
3. Insert BATTERY (4) into BATTERY HOLDER (5), make
sure the shape of the BATTERY (4) follows the shape
of the BATTERY HOLDER (5) and terminal end is
inserted rst. Fig. 1b.
4. Insert the BATTERY CONNECTOR (5a) for the Standard
Battery or PWRX Battery Pack through side GROMMET (6)
as shown. Fig. 1c.
5. Connect SOLENOID CABLE (7) and BATTERY
CONNECTOR (5a) to SENSOR CABLES (2). Place
Standard Battery or PWRX Battery Pack into Housing.
Fig. 1d.
6. Replace CONTROL BOX COVER (1). Tighten cover
screws rmly.
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any components
will void the warranty.
Product Page
Plug-In AC Power Kit (PK00.PAC)
6
Hard-Wired AC Power Kit (PK00.HAC)
6
Multi-AC Power Kit (PK00.MAC)
7