Installation Guide

ManualsBrandsAmerican Standard ManualsBathroom Sink Faucets206B106.002

Installation Instructions

Certied to comply with ASME A112.18.1

NOTE TO INSTALLER: Please give this manual to the customer after installation.

To learn more about American Standard Selectronic

Products visit our website at: www.americanstandard-us.com

or e-mail us at: CRTTEAM@americanstandard.com

For Parts, Service, Warranty or other Assistance,

please call (844) CRT-TEAM / (844) 278-8326 (In Canada: 1-800-387-0369)

(In Toronto Area only: 1-905-306-1093)

SERIN

™

Deck Mount Electronic

Proximity Lavatory Faucet

CAUTION: Use only American Standard supplied

transformers and cable sets. Using non-AS supplied

cables, or cutting, splicing or modifying any components

will void the warranty.

Optional 206P400.XXX, 4" Deck Plate

Optional 206P800.XXX, 8" Deck Plate

Product No’.s & Options 1

Specications 2

Faucet Installation 2-3

Electrical Installation 4-6

Start-up / Maintenance 7-8

FAQ’s / Troubleshooting 8-9

Replacement Parts 10

M965612 Rev. 1.7 (11/16)

MODEL NUMBERS

2064.14X 2064.15X 206B.10X

Summary of content (11 pages)

PAGE 1
Installation Inst ru ct io n s SERIN™ MODEL NUMBERS 2064.14X 2064.15X 206B.10X Deck Mount Electronic Proximity Lavatory Faucet CAUTION: Use only American Standard supplied transformers and cable sets. Using non-AS supplied cables, or cutting, splicing or modifying any components will void the warranty. Optional 206P400.XXX, 4" Deck Plate Product No’.
PAGE 2
Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. UNPACKING All American Standard Products Are Water Tested At Our Factory. Some Residual Water May Remain In The Valve During Shipping. Remove the fitting and loose items from the carton. The illustration below shows all the fittings and loose items after they have been removed from the carton.
PAGE 3
Roughing-in Dimensions GENERAL DESCRIPTION: Electronic faucet with proximity operation. Vandal resistant solid brass construction single post mounting. Operates on DC (battery/power pack) or AC permanent power (plug-in/hardwire). In-line strainer for solenoid is integral. Single inlet 3/8 compression, built-in check valves, and flexible stainless steel 16-1/4" reach inlet hose for spout connection.
PAGE 4
2 MOUNT CONTROL BOX; Fig. 4 ! Fig. 4 LAVATORY RIM OR MOUNTING SURFACE Important: For AC installation, make sure power supply connector is inserted into control box through power supply grommet before control box is mounted to the wall. Reference electrical installation section (pages 5 & 6). WASTE NOTE: CONTROL BOX SUPPLY HOSE is 20". Distance between wall supply and CONTROL BOX (3) must be taken into consideration. 1524mm (60") 20" (500mm) 21" (mm) 3" (76mm) 3-3/4" (96mm) MOUNTING HOLES 2.
PAGE 5
ELECTRICAL INSTALLATION Product Fig. 1 1 Page Plug-In AC Power Kit (PK00.PAC) 6 Hard-Wired AC Power Kit (PK00.HAC) 6 Multi-AC Power Kit (PK00.MAC) 7 Fig. 1a 2 Fig. 1b 3 5a 5 A DC VERSIONS (PWRX & STANDARD BATTERY); Fig. 1 INSTALL BATTERY 1. Remove CONTROL BOX COVER (1). Fig. 1. 4 2. Feed the SENSOR CABLES (2) through the top of CONTROL BOX (3). Fig. 1a. STANDARD BATTERY Fig. 1c 3.
PAGE 6
B AC VERSIONS Fig. 2 (HARDWIRE / PLUG-IN); Fig. 2 CAUTION 2 Before opening CONTROL BOX disconnect AC power supply. 3 1 NOTE: For AC installation, make power supply connection before mounting CONTROL BOX (3) to wall. 1. Remove CONTROL BOX COVER (1). Fig. 2. Feed the EXTENSION CABLES (2) from the Faucet through the top of CONTROL BOX (3). Install CONNECTOR LOCKING DEVICE (16). Fig. 2. FOR PLUG-IN HOOKUP ONLY 2a. Insert POWER CORD (8) through POWER SUPPLY GROMMET (9). Fig. 2a. 3a.
PAGE 7
Fig. 3 Unit #1 Unit #2 Unit #3 10 ft. EXTENSION CABLE 10 ft. EXTENSION CABLE AC POWER SUPPLY *MAXIMUM OF 15 UNITS PER AC POWER SUPPLY. 10' MAXIMUM CABLE LENGTH BETWEEN UNITS. OR AC HARDWIRE POWER SUPPLY 4" (102mm) SQ. X 3-1/2" (89mm) DEEP CONTROL BOX Hubbel-RACO #256 OR EQUAL (BY CONTRACTOR). OR AC-VERSION C F Unit #1 Detail Fig. 3a (MULTI HOOK-UP); Fig. 3, 3a, 3b 3 SENSOR CABLES 1. Remove COVERS from all CONTROL BOX (2). 2.
PAGE 8
START-UP / MAINTENANCE Fig. 1 AND WASH SENSOR A H ! OPERATION; Fig. 4 rior to making power connection, make sure P detection zone is not obstructed. Sensor is self adjusting. Keep detection zone clear for 15 seconds after power is connected. ION ECT T E D E: ZON EN E W BET T AND U O NK P S F SI EO S A B When the Sensor detects a user, the water immediately starts to flow. Water flow will stop 1.5 seconds after user is out of sensor range.
PAGE 9
OW TO CLEAN AND REMOVE D H Fig. 4 THE AERATOR OR SPRAY; Fig. 4 9 1. Remove Aerator or Spray HOUSING (7) with KEY supplied with faucet. 8 2. Remove Aerator or Spray (8) from HOUSING (7). 7 7 3. Clean the Aerator or Spray SCREEN (9). 4. Reassemble and install into spout end. Be sure the black seal washer is in place. KEY E HOW TO CLEAN FLOW REGULATOR; Fig. 5 Fig.5 3 1. Remove SUPPLY HOSE (1) from top of CONTROL BOX ASSEMBLY (2).
PAGE 10
TROUBLESHOOTING FLOW CHARTS UNIT DOES NOT FUNCTION ARE EXTERNAL SUPPLY STOPS OPEN? NO OPEN EXTERNAL SUPPLY STOPS. NO OPEN INTERNAL SUPPLY STOP. (HEX KEY NEEDED) YES CRITICALLY LOW BATTERY. INSTALL NEW BATTERY. YES IS INTERNAL SUPPLY STOP OPEN? YES REPEATED DOUBLE FLASH ON SENSOR? NO RECONNECT BATTERY TO SENSOR. DOES SENSOR FLASH FOR 5 SECONDS? 1 2 NO NO YES 1 2 DEAD BATTERY. INSTALL NEW BATTERY. REPEAT. CHECK FOR DAMAGE TO SENSOR WIRE INSULATION. REPLACE SENSOR.
PAGE 11
SELECTRONIC® Deck Mount Electronic Proximity Lavatory Faucet Replace the "YYY" with appropriate finish code CHROME SATIN NICKEL All 2064. SERIES 002 295 MODEL NUMBERS 2064.14X 2064.15X 206B.10X M964912-0070A SPOUT TIP SENSOR M964913-YYY0A AERATOR KIT (1.5 GPM) M964847-YYY0A A912699-0070A M962353-YYY0A SEAL ESCUTCHEON KIT SPRAY KIT (0.5 GPM) M964964-YYY0A AERATOR KIT (0.35 GPM) PWRX Battery Pack 2064.