Installation Guide

3
1
SPOUT ASSEMBLY
INSTALLATION; Fig. 1
1. Make sure O-RING (3) is installed into groove in
ESCUTCHEON RING (4).
2. Insert SENSOR CABLES (1), SPOUT HOSE (5) and
SPOUT SHANK (6) through center hole of mounting
surface. Fig. 1.
3. Assemble RUBBER WASHER (7), BRASS WASHER (8)
and LOCKNUT (9) onto SHANK (6) from underside of
sink or mounting surface. Hand tighten LOCKNUT (9).
4. Use a screwdriver to tighten SCREWS (10) on
LOCKNUT (9). Work your way around LOCKNUT (9),
tightening the screws slightly each time until all are
snug to ensure even pressure.
Note: 4" and 8” Deck Plates (11) are available for other
installations, see page one for information.
5. When using optional 4" or 8" DECK PLATE (11) rst
thread the DECK PLATE CENTERING NUT (12) onto
SHANK (6). Thread the DECK PLATE CENTERING
NUT (12) tight against the underside of the faucet base.
6. Follow steps 1-4 above for the spout installation.
Roughing-in Dimensions
1. Slip Joint Pliers
2. Adjustable Wrench
3. Plumbers’ Putty or
Caulking
4. Phillips Screwdriver
5. Flat Blade Screwdriver
6. Electric Drill & 1/4"
Drill Bit
7. Tape Measure
1
2
3
4
5
6
7
10'
M965612 Rev. 1.7 (11/16)
114mm
(4-1/2")
500mm
(20")
1524mm
(60")
413mm
(16-1/4")
3/8" COMP.
32mm
(1-1/4") DIA.
125mm
(4-7/8")
81mm
(3-3/16")
MOUNTING
SURFACE
(249mm)
9-3/4"
(173mm)
6-11/16"
(100mm)
3-15/16"
(136mm)
5-3/8"
(177mm)
7"
RECOMENDED CONTROL BOX OR
EQUIVALENT BY OTHERS
HARD-WIRED AC ONLY 10' MAX. CABLE LENGTH
4" (102mm) SQ. X 3-1/2" (89mm) DEEP CONTROL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal resistant solid brass construction
single post mounting. Operates on DC (battery/power pack) or AC permanent power
(plug-in/hardwire). In-line strainer for solenoid is integral. Single inlet 3/8 compression,
built-in check valves, and exible stainless steel 16-1/4" reach inlet hose for spout
connection.
Note: All plumbing and electrical wiring must be installed in accordance
with applicable codes, regulations and standards.
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any components
will void the warranty.
RECOMMENDED TOOLS
CAUTION
Turn off hot and cold water
supplies before beginning
Fig. 1
2
11
*12
4
3
1
SENSOR
CABLES
5
7
8
9
10
PUTTY
(If required)
IMPORTANT: Do not
use putty when installing
faucet without escutcheon.
MOUNTING
SURFACE
*(#12 CENTERING NUT) is
only used with the
installation of a 4" or 8"
deck plate
6