Installation Guide

7302073-100 Rev. A
3 4 5
CLOSET FLANGE
CLOSET BOLTS
A
WAX RING
SEALANT
INSTALL WAX SEAL
Invert toilet on floor (cushion to
prevent damage), and install wax
ring evenly around waste flange
(horn), with tapered end of ring
facing toilet. Apply a thin bead of
sealant around toilet base.
POSITION TOILET ON FLANGE
a.
Unplug floor waste opening and install toilet on
closet flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked "THIS SIDE UP" must face up!
CLOSET
BOLT
NUT
TAPERED
WASHER
FLANGE
6
8
7
INSTALL TOILET
a. Position toilet squarely to wall and, with a rocking motion,
press bowl down fully on wax ring and flange.
Alternately tighten nuts until toilet is firmly seated on floor.
CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut bolt height to
size before installing caps.)
c. Smooth off the bead of sealant around base.
Remove excess sealant.
INSTALL TANK
a. Install large rubber gasket over threaded outlet
on bottom of tank and lower tank onto bowl so
that tapered end of gasket fits evenly into bowl
water inlet opening.
b. Insert tank mounting bolts and rubber washers
from inside tank, through mounting holes, and
secure with metal washers and nuts.
c. With tank parallel to wall, alternately tighten
nuts until tank is snugged down evenly against
bowl surface.
INSTALL TOILET SEAT
Install toilet seat in accordance with manufacturer's directions.
CLOSET FLANGE
CLOSET BOLT
NUT
WASHER
BOLT CAP
RUBBER
GASKET
TANK MTG.
BOLTS
NUT
WASHER
!
CAUTION:
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
RUBBER
WASHER
!
- 2 -
INSTALL CLOSET BOLTS
Install closet bolts in flange channel
and slide into place parallel to wall.